Interested to Buy Any Domain ? << Click Here >> for more details...
How i can identify the 220V and 110V power supply equipment?
No tag number.
- 4 Answers
- 7585 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikramsena_reddy
for blind if equipment is made in USA, JAPAN, KOREA that
should operate on 110/220v.
| Is This Answer Correct ? | 2 Yes | 14 No |
Post New Answer View All Answers
what are the tests comes under the type test, what tests comes under routine tests.
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
Sate maximum power transfer theorem?
How to resolve if Diesel generator stop while running ?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
what are factors to be consider in electrical installation like load factor,diversity factor .....
How much ph is maintained of water resistance starter for slipring induction motor ?
What are stable systems?
what is the control circuit for operating the clean room air shower
HOW TO DESIGN THE body EARTH cable(Copper Conductor) size for 60KVA UPS?
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
