wat is the importance of reactive power in power
generation.....if it is zero means wat will happen to
system........
- 22 Answers
- 37400 Views
- Bhel, Jindal, I also Faced
- E-Mail Answers
Answer Posted / girish kumar samal, hindalco,h
it is a serious case. system vltage goes down. as we have
many inductve load. if there is only resistive load or
impedance of the system is minimum (near= 0)
then its ok.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
Give atleast 20 alternating current apparatus and devices.
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
What would be the size of wire used for 2 Ton of window A.C?
I have finish diploma electronics and five years experience in electrical field in ht service how can i get c licensce or other electrical certificate
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
What do you understand by oldham's coupling ?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
List the characteristics of filter?
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
What is different bewteen low or high impedance busbar protection scheme
Is a d.c.compound motor is use as a booster? how?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
