why should series motor be started with load and shunt
motor should be started without load??????
- 7 Answers
- 23451 Views
- I also Faced
- E-Mail Answers
Answer Posted / mayank sharma
if series motor starts without any load,ie open circuited
condition...a very less flux will be generated that is
mainly due to residulal flux and hence speed being inversly
propotional to flux,a speed (theoritiaclly infinite)will be
there at starting and hence its not started at no load in
the begning.
there is no such compulsion in dc shunt motor but running
it on no load in starting ensures that the good amount of
working flux will get generated before load is applied.
| Is This Answer Correct ? | 11 Yes | 7 No |
Post New Answer View All Answers
what is kondo syatem in eletrical traction
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
what is the IPC ? & what the uses ?
how can motor both beasrings insulation resistance can be check?
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
What is negative sequence over voltage element?
what is the ground fault relay,which purpose it will be use,clearly tell me plz
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
what is the circutor?why we use it ?
