why should series motor be started with load and shunt
motor should be started without load??????
Answer Posted / pandi
in series motor field winding is series to armature winging.
at starting condition we control starating current for
prevent the winding from over current.so flux
low.N=1/flux.so motor rut at dangerous speed.to avoid that
start with load.
in shunt motor field winding is parallel to armature
winding.the field is current is mostly constant.so flux
also constant.sppeed also constant
Is This Answer Correct ? | 45 Yes | 9 No |
Post New Answer View All Answers
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
what is the difference between electrical and electronic choke?
which network topology offers the greatest level of tolerance?
how does an encoder work???
Difference between RCCB, RCBO and ELMCB.
What is power in wattage of 8.5 TR AC
what do w do when the output of generator is fluctuating?
what about GD square and its important for motor design?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
What we mean by vintage of an engine+Generator?
how to check ac servo motor
Draw the line diagram of diffretial relay connected to transformer?
Why we use mho Relay in long transmission line?
How to calculate loses in transformer of 160 KVA ?
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.