Interested to Buy Any Domain ? << Click Here >> for more details...
if we convert ampers into kw,which one formula use by
us,pls tell me?
- 11 Answers
- 19916 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rangnath
For AC Circuit,
KW = (V*I*PF)/ 1000
And For DC Circuit,
KW = (V*I)/ 1000
Where V = Voltage, I = Current, and PF = Power Factor
| Is This Answer Correct ? | 25 Yes | 5 No |
Post New Answer View All Answers
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
How many types of protection relays are there based on the characteristic?
which type of cabel
State ohm’s law?
ratings of lightning arrester
How to select a transformer group to connect a 0,433 KV generation with 33 KV grid in bi directional flow of current
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
how to select the no. of brushes in a lap winding?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
Why to keep capacitor bank off while generator running.
i completed my DEEE. and i want to electrical c license. how to get it..?
