What is the differance between negative dc voltage and
positive dc voltage because some circuit uses -24,-5,-12,-
15,volt dc supply
Answer Posted / sarav3387
DC voltage has either -ve OR +ve polarity. in case,
you connect +ve polarity to ground and -ve polarity to
source, at that time it produces negative DC voltage.
A negative DC supply usually is used along with an
positive supply in audio electronics in order to produce an
AC output (both positive and negative voltage excursions
with respect to the zero volt level) which represents the AC
nature of the typical audio input signal. The only other use
for a negative supply voltage that I can think of is mostly
a thing of the past but old fashioned ram chips required a
+5, +12, and -12v supplies.
Is This Answer Correct ? | 35 Yes | 9 No |
Post New Answer View All Answers
plz send me the procedure and syllabus for mseb exam
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
can u give me a brief idea about power line carrier communication ??
Why let through energy not considered for ACB breaker while cable sizing?
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
What is order of the system?
Why Neutral Isolation is required?
what mean by analog ,digital,numerical meters and relays? say the example?
Why the power factor improvement is so important in industrial loads
What is the role of power pack in substation protection system?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is