Interested to Buy Any Domain ? << Click Here >> for more details...
Wht ar the reason for low voltage on consumer side?
- 6 Answers
- 9231 Views
- I also Faced
- E-Mail Answers
Answer Posted / mani
The low voltage mostly in the peak hours why because that
time more number of consumers are using the power.So the
voltage will get reduced on the distribution line.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
If not into production, how far did you follow the design and why did not you see it into production?
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
what are the disadvantages in GIS over AIS
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
What is the maximum percentage voltage drop (vd%)for a motor control center
what is saturation kit?which use above 15 kw motors panel side.
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
what do w do when the output of generator is fluctuating?
could you measure current in parallel?
Why front mounted CT polarities are always towards breaker?
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
