Interested to Buy Any Domain ? << Click Here >> for more details...
what is silica fumes or micro silica? and whr is it used?
wat r its advantages?
- 10 Answers
- 26386 Views
- I also Faced
- E-Mail Answers
Answer Posted / adityadmrc
Silica fume is 100 times more finer than cement. the
surface area for opc cement is 225 sqm/kg. silica fumes
gives more strength to the concrete as it fill the void
which exist between the cement partical Delhi metro rail
corporation is going to used for designing m80 or more
grade concre
| Is This Answer Correct ? | 54 Yes | 3 No |
Post New Answer View All Answers
what is the mode of method of face bar measurement
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
At what point does a circle start losing area when being flattened?
Can we apply curing compound on ceiling (slab Bottom)
Which is the latest version of solidsworks?
In cement concrete how to check a quality of material also proportion of material at site ?
How do you measure water flowing through 300mm diameter pipes?
load combinations how many types for staad design purpose?
Hi all, please guide me about the volume. And percentage. Of steel fibre to be used. My project. Is Sifcon.
what is yield and tensile strength of steel, if steel has yeilding strength of 60 psi than how much its tensile strength?
Why are steel plates inserted inside bearings in elastomeric bearing?
how to control PQI (Project Quality Index)
Explain the mechanism of cavitations in pipes and drains?
What is meant by autocad?
What is Refuse Area In High Rise Building ?
