Interested to Buy Any Domain ? << Click Here >> for more details...
what is the differents and advantages of Electro magnetics
relay and static relay ? what is the numerical relay ?
advatages?......
- 7 Answers
- 23970 Views
- CAT, L&T, TCS, I also Faced
- E-Mail Answers
Answer Posted / jagan
Static (Stationary) Relay(Switching device) - Electronics
Switching Devices(Thyristers -SCR, TRIAC and et cetera)
Electro-Magnetic Relay - Relay that contains Core coil and
moving core(E & I Core) stationary contact & Movable
contacts
Another, logic AND, OR, NOT, NOR, Ex-OR
| Is This Answer Correct ? | 26 Yes | 4 No |
Post New Answer View All Answers
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
what is transient stability analysis means?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
State nyquist stability criterion.
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
How can we calculate the motor frame sizes?
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
what is the clear formula to calculate cable size for a load
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
What are the different circuits in thermal power plant?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
