Interested to Buy Any Domain ? << Click Here >> for more details...
What is the air flow rate at suction, if impeller of dia
1500mm and it consists of 8 no's vane, running at 1500 rpm?
Dia of suction pipe is 500mm.
- 1 Answers
- 5292 Views
- I also Faced
- E-Mail Answers
Answer Posted / gurmeet singh
The air flow rate at suction pipe is= (Area of suction pipe)
*(Velocity of air at suction pipe)
We know that area of suction pipe = pie/4 * D*D
Where D= 500 mm
So area of suction pipe = 196250 mm2
Know we have to assume that velocity at suction pipe ens is
just equal to the velocity in impeller.
Velocity of impeller= pie*D*N/60
= 117750 mm/sec
So air flow rate = 196250*117750
= 23108437500 mm3/sec
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What type of pump is commonly used is feed water system in auxiliary boiler?
What are the some examples of a periscope?
How many mechanical engineers work with you at your place of employment?
how to design a crankshaft?
please provide me the calculation for the thickness of duplex stainless steel pipeline thickness used in process industry ( Water). The details are given below. Diameter : 3" and 4" Thickness : 3.91mm, SCH40 Operating pressure : 62 bar Operating Temp : 35 degree ASME31.3
How to calculate the no of straps required to hold a bar bundle which varies in different length? Ex say 6M bar ,weights 1.3 ton with 250 bars in the bundle.
Define nusselt number [nu].
. how will effect of water injection on turbine load and corresponding MW output(not water washing)
Dear friends, i am a student of mechanical final year in rajasthan. If you have any type (Technical,interview, aptitude) of question paper related to BIRLA CEMENT LTD. than plz send me these paper at vinodsainikumar4@gmail.com thanks
What is difference between ASME EN & IS related welding procedures(WPS/PQR/WPQ)
What are some of the projects you are currently working on in engineering?
What is difference between Higher calorific value and lower calorific value?
What are the requirements of a good fuel?
Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison
In Turbine how the balence piston works and what is the direction of leak of steam flow.
