Interested to Buy Any Domain ? << Click Here >> for more details...
Why used in layer by layer charcoal and salt used in earth
pits.
- 11 Answers
- 71853 Views
- CESC, HP, I also Faced
- E-Mail Answers
Answer Posted / rajesh tokalapudi
The layer of charcoal and salt helps to maintain low
resistance for earth fault currents.Because of ionic
behaviour of salt and charcoal they will maintain moisture
content around the earht pit.
| Is This Answer Correct ? | 114 Yes | 10 No |
Post New Answer View All Answers
how to increase or decrease speed in DC shunt motor by DC convertor
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
what is meant by skew width in machines?
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
Explain the functioning of diode?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Explain what is rated speed?
Bimetal strip used in overload relay what is that,which types of material used for that & percentage.
mccb service sittings be done?
Explain the operation of grid connected central solar inverter ?
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
