Interested to Buy Any Domain ? << Click Here >> for more details...
why transmission line 11Kv OR 33KV,66Kv not in 10kv 20kv?
- 43 Answers
- 125220 Views
- A2Z Group, Baiji Power Plant Gas, Electrical, HCL, Kirloskar, Mepco, NEPC, OAMC, UNI, University of Lahore, I also Faced
- E-Mail Answers
Answer Posted / kishore
FORM FACTOR of sine wave is 1.11
rms/avg=(im/root2)/(2*im/pi) = 1.11
FF of square wave is 1.00 n triangular is 1.15
so i think form factor is not the only logic behind
11kv/33kv but while the generator o/p formula suggest there
are certain terms multiplied with the form factor(1.11) n
it is forcibly made to a standadadised value by changing
certain parameters..
| Is This Answer Correct ? | 34 Yes | 16 No |
Post New Answer View All Answers
i am in need of AC SYNCHRONUS MOTOR 30KW. ANY ONE KNOWS THE MANUFACTURER OF SAME. ALSO MOSFET AC CONVERTER 20KVA CONT.OUTPUT.
Where voltage are high and current to be interrupted is low the breaker preferred is:
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Why syn. Generators are used for the production of electricity?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
On what cycle does thermal power plant operate?
why do we have spikes enough to burn electronic boards, when generators are not grounded
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
What is the formula to calculate the size of Aluminium and copper cable?
what is parellel power factor correction?
