Interested to Buy Any Domain ? << Click Here >> for more details...
What is the min and max ohmic value for earthing?
- 15 Answers
- 40554 Views
- NewTek, Wipro, I also Faced
- E-Mail Answers
Answer Posted / satya dev ( knight frank)
It is depending on usage
LV- for copmutor/ electronic device --- 0- 1 ohm
for UPS --- 0- 1 ohm
HV - for substaion/ power generating system- 0- 5 ohm
but 0 is not possible.
| Is This Answer Correct ? | 32 Yes | 4 No |
Post New Answer View All Answers
Give some differences between open loop and closed loop?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
what is the ground fault relay,which purpose it will be use,clearly tell me plz
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
solar energy light efficiency & disadvantages?
what is per unit calculation?looking for simple and strong explanation thk u
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
why we testing the core balance of the transformer before comissioning?
please send me the previous year's question papers of jindal GET exams
