Interested to Buy Any Domain ? << Click Here >> for more details...
One watt is equal to how many?
we says one watt bulb,means what it consume?
- 3 Answers
- 8389 Views
- I also Faced
- E-Mail Answers
Answer Posted / satya dev ( knight frank)
Consumption of 1 w bulb-
P= VI
suppose - V - 230 Volt,, P= 1 W, I-- ?
then I = p/v= 1/230
P= .0043 Amp.
Power Cons. KWH = KW X 1 ( suppose - 1 hrs)
1/1000 X 1
= .001 unit for 1 hrs.
| Is This Answer Correct ? | 25 Yes | 2 No |
Post New Answer View All Answers
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
What is the difference between a fuse and a breaker?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
describe the fully control circuit diagram of ac drives
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
Which type of transformer is used for lighting loads?
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
what is the use of piston rings in the engine used for a generator...........
What do you mean by screen of power cables?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
