Answer Posted / prabhu gnanasekaran
AS Per IS:1554(Part1)&7098(Part1)
AYFY
A-Aluminium
Y-inner shealth for insulation
F- Flat armoured(There is one more thing WOUND ARMOURED)
Y-outer shealth of insulation.
In general practice
Cable sizes upto to 3CX10 Sq.mm Wound armoured is
acceptable.( Wound armoured will provide a good mechanical
strength than Flat armoured)
Cable are selected with FLAT ARMOURED is mainly because of
finacial reasons and some phical resons in errection and
maintance
Is This Answer Correct ? | 42 Yes | 8 No |
Post New Answer View All Answers
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
what is meant by 2 within a star in a voltmeter dial?
How to measure size of cable on a given load
We have two parts in generator, electrical & mechanical. how it works?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
How do we calculate over and under frequency tolerance from generator data?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
Why induction motor is widely used in industry
What is meant by Low Resistance Cable and High Resistance Cable.
Graphs of measuring power and speed on dc motor
how to synchronize 3 phase slip ring induction motors of different ratings.
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042