Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / atul rastogi
Inrush current is the current drawn by the load at the time
of switching. It depends upon starting impedence of the
load as some load have changing impedence depending upon -
temp., fr. etc.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
how to failure indution motor insulation & how to improve heat in motor insulation
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
List few applications of d.c series motor?
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
Brief me about maintenance planning & sheduling of machine tool.
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
what is charger supervision and control supervision?
why we use circuit breakers for switching instead of normal switching device?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
