Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / divi
neutral is used to prevent the device from faults.it
reduces the over current flow.
| Is This Answer Correct ? | 14 Yes | 6 No |
Post New Answer View All Answers
why co incidence factor considered in transformer sizing?
1hp= how much rpm
What is the purpose of stablization resistor in high impedance bus bar protection
What is the exact minimum vale of voltage between an earth and netural which can damage or can do malfunction of the electronic equipments ? If this is mentioned in any book, pl.give reference.
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
What is pd controller?
What is load boxes ?
How many double suspension hardware fittings are required on a double circuit transmission tower?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
