Answer Posted / k.babu
Netural -Zero Potential , & The Earth, which is used to
transfer the Leakage current
Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
Show the schematic arrangement of diesel power station layout and give its principle of operation.
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
what is the mechanical safety of DG ?
difference between ac series and parallel circuit
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
What we mean by vintage of an engine+Generator?
how to calculate fuse rating for a motor
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
is that any software calculator to calculate the size of cable
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?