whether it is possible to read stored data from a
microcontroller by using any device.
Answer Posted / vivek
yes definitely, The data on the RAM of the microcontroller
can be moved to any of the I/O ports where the device can
be attached to display the data(e.g. LCD)
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what are the differences between dcs & plc & scada?
Give the difference between transducer and transponder?
Explain the difference between plc and dcs?
Can we use ic 741 for high frequency applications?
i want exam information bhel, nal, hal, bel you have any idea or any question papers or placement papers please send soon
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
State the different types of flip flop?
On what parameters does the free running frequency of vco depend on?
box1-2 box2-12 box3-350 using multiplication and division only bring 74 in box 3 in 3steps
Compare csi and vsi?
4 Stage ripple counter with delay(f/f) 10msec. How much time it takes for a state to change. 4*10=40.
i having three wire RTD but i want analog input signal 4 to 20ma to Allen Bradly plc.so how to connect this one.pls clarifie me.
The positive clipper can be easily converted into negative clipper by A Reversing diode and changing the polarity of reference voltage B Reversing diode only C Changing the polarity D None of these
what is a voltage follower?
Explain in detail the thevenin`s theorem