Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kamran
dcs is a control system in which the controller elements are
not central in location but are distributed throughout the
system with each component sub-system under the control of
one or more controllers
| Is This Answer Correct ? | 134 Yes | 15 No |
Post New Answer View All Answers
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
what is basic difference between motion balance and force balance in pneumatic instrument?
which type of filter gives the constant phase characteristics?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
types of cable..? Use of every types of cable..?
what is span value and zero ? and how set ?
Explain about the leakage class of the control valves
Why do you want to work here
how to calculate control valve bonnet size?? or how to select its material?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How we connect a instrument with ground, Give brief explanation with help of diagram?
send me last 5 years questions asked in rrb chennai, for section engineer
