Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / naved hamid
the answer to this question is that electronic meter
possess a microprocessor which is interfaced by a
Programmable Periphral Device which receives its Input from
Two CT's, one is on the phase & the other is on the
neutral,the PPI recieves signals from both CT,s but it
reads whichever the current is greater & a V.T. is
positioned in the casing of Energy meter of which outputs
is fed to PPI so the proceessor reads V from V.T.,I(depends
on Power Factor) from C.T. so their product is seen on the
digital screen of the Meter.
| Is This Answer Correct ? | 74 Yes | 17 No |
Post New Answer View All Answers
How cable from Kit-Kat to main switch, from starter to motor are designed?
what is the electrical?
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
11000volt DG set carnt kaise banvay
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
why we are not giving the zone 1 trip command to the master trip relay
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
WHAT IS THE USE OF PIG TAIL IN WINDOW CT ?
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
what is acceptance test in electrical engineering.
how the works electronic energy meter?
how to produsing geretor power
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
