Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT HAPPEN WHEN CT SECONDARY OPEN DURING LOAD
- 16 Answers
- 32437 Views
- Neco, I also Faced
- E-Mail Answers
Answer Posted / javed
CT means current transformer which help us to measure the
large amount of current by step down the value of current
to low value. CT primary wdg handle the large amount of
current due to which large amount of heat is produce at
primary winding so we use insulating oil which help to
provide insulation as well as provide cooling. If we open
its secondary winding, the secondary current will reduce to
zero, which cause increase in voltage across its secondary
open terminal and that leads to increase in primary
current, with increase in primary current temperature of
oil in CT also increase and oil start burn which leads to
blast in CT
| Is This Answer Correct ? | 33 Yes | 6 No |
Post New Answer View All Answers
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
how can we make cable shedule for controll wiring ? which details must be required for it.?
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
What is Control & Relay Panel? And Remote Control Center?
Give some example of fault limiting devices?
What is excitation in case of dc motor?
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
please send me privious exam's queation papers of section engineer(electrical).
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
