How to increse bearing capacity in soils (Stabilisation of
soils)
- 12 Answers
- 17881 Views
- I also Faced
- E-Mail Answers
Answer Posted / ayyappan govindasamy
150mm thick /layer to be spread and every layer proper
compaction to be done
relative compaction valves minimum 98%-100% shall be
required
OMC to be controlled and mixing to be done adequately and
thoroughly
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
qty. of cement & sand required (100sq.mtr) for fixing of floor and wall tiles also fixing of marble stone on the floor
std penetration resistance in very stiff clays lies bet 2 & 4 4 & 8 8 & 15 15 & 30
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
writte a c prog. to acept 5 no. from consule and then display them back on consulte in ascending order
What are the standard plastic limit/liquid limit/plasticityindex for differrent type of soils?
sir how can we find the cement and sand required for making 4" drop
why we are useing plastic under the lean concrete?and whts the advantage?
Howmuch bend to be provide for 200/600 BEEM
What are the important hardware systems used for cad?
At what point does a circle start losing area when being flattened?
can stub column take the load as main column
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
What are the causes of building collapse?
What is the density of Fiber reinforced concrete and give me the which fibers we can use in Concrete?
we have a bore well 275 depth & water is deliver at distance of 1000 feet from the borewell here iam not include the distance of depth and the deliver water horizontally at our reserviour tank on ground level
