Answer Posted / prasanna
Flow of electrons
| Is This Answer Correct ? | 133 Yes | 22 No |
Post New Answer View All Answers
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
specify the inbuilt protections in DG
Why is negative feedback invariably preferred in closed loop system?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
What is electrical cable termination
why lightning arrestor are made in two stack of insulator but why not cvt
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
A cotter joint is generally used to transmit
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
why we used dc supply for field in dg set
What is the classification of hydro projects based on installed capacity?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
What the main causes of transient interruptions on Over-Head Distribution Lines?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
Write a note on materials used as a fuse element.
