what principle the cabel TV channels are transmitted? will
you be able to check the power at the connector behind your
TV with a tester?If yes what is the supply level?
- 1 Answers
- 3867 Views
- I also Faced
- E-Mail Answers
Answer Posted / r.thirumoorthy
IT OPERATES ENCODER PRINCPLES
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
For a stable system, where should the poles of a system be in a root loci plot?
What do you mean by a current transformer?
What happens if i apply 500V to 440V rotary Switch ?
What happen Grid EARTH plat got cut.
for compensate 315mh inductance ,how many capaciance required?
Advantage of LT panel vs HT panel
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
why the active power flow of some line is increased when the active power of out is cut ?
what is the common earth
How many devices can be connected in one zone of FACP
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
