Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manasa
Power factor is the ratio between active (real) power to
the apparent power i.e
PF = P/(√P2+Q2)
The power factor can also be calculated from the following
equation provided that the phase difference between the
current and voltage have been measured:
PF = Cosφ
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
what will happen if synchronous machine rotor fed from single phase ac supply
what purpose to use excaiter in DG.?
what is the transiant condition in alternator? and how it can be prevanted?
why ct ,cvt should be stored in a vertical position?
why transmission is only 3 phase and not 2 or 4 or poly phases
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
Define pole pitch?
If a high resistance fault occurs,then what are the changes will happen in the system?
What is the test block protection relay if any body know plz explained
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
hello! sir i did three year of diploma in electrical (2007- 2010) and now i m a student of electrical engineering. sir can i apply for germany visa for study and part tome work over there?
what could be the RMS value and average value of a 4 phase sine wave?
wat is d diffr btw shunt coil and trip coil in VCB?
