Why DC excitation is used for alternators? Why cant it be AC?
Answer Posted / abid ali khattak
As you well known the DC is direct current which doesn't
change its direction. therfore we always using the DC
excitation for Generation due to continues induced magnatic
field for proper excitation.
| Is This Answer Correct ? | 131 Yes | 43 No |
Post New Answer View All Answers
Can an inverter be used as a converter? How?
how to commissioning the genset with amf panel?
what ispositive, negative, zero sequence impedence?
explain the Trip supervision circuit
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
explain single phase series motor
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
what is the working principle of a DG Set, Alternator, & exiter
How to see the inductance in a transmission lines
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
how does ELR works? explain
Role of active and reactive Power sharing in between two synchronized Generators, Droop Setting role ?
What is effect of over voltage and under voltage on ACB
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
Mention the difference between Analogue and Digital circuit?