Answer Posted / asim raza
in star conection 3 ends of the coils are comon other 3 ends
open for supply
phase crurrent and line crurrent same
line voltages=1.742phase voltages
indelta sex ends conect each other
line v=phase v
line crurrent=1.742phase crurrent
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
What is pi controller?
operation of diesel generator
State the other types of Air Conditioners?
Explain cos(theta) and Sin(theta)
Difference between low impedance and high impedance Restricted Earth Fault
What is knee point voltage of transformer?
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
Explain and give examples about VCB?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
