Interested to Buy Any Domain ? << Click Here >> for more details...
I have recently seen a transformer which had two primary
terminals and was connected between two lines,i would like
to know what kind of transformer is it?short discription
about it,any advantages,purpose of usage of the
same.............
- 8 Answers
- 10937 Views
- I also Faced
- E-Mail Answers
Answer Posted / gaurav
BUT BUT
its not transmission or distribution transformer my friend
its inside a machine which uses three phase supply
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Give some differences between open loop and closed loop?
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
How to decide DO set rating of Transformer?
What is the function of interposing current transformer?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Why power factor should not be in leading (capacitive) mode of any load.
Please brief what is sinewave
i applied for the ap transco please forward the freqventley asked QA
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
What is the difference between indoor and outdoor transformer
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
How many types of probe used in cro?
how point on wave controller works.
In parallel operation time both NGR’s close or not close if both close what will happen
What the difference between ac and dc inductor an capacitor
