As Electricity Generates in MW I w'd like to know What are
the factors we have to consider regarding the transmission
of electricity from generation station to Public uses(230 V)
Answer Posted / bikash
As far as transmission of power is concerned the main
factors are
1. Transmission line drop
2. Switch gear And Protection required that is as per
voltage level.
3. Steady state limit and transient stability limit.
4. Thermal limit of trans. line.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How do u analyse protection fault when vcb tripping on load
how to calculate cable size in diffrent loads?
What is meant by cold loop test in instrument
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
describe the constructional features of an auto transformer and its principle operation
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
tell me about eletrical contractor
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
how to calculate magnetic force genrated by a coil ?
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
what is the saturation point of crgo lamination.