Interested to Buy Any Domain ? << Click Here >> for more details...
IN ALLEN BREADLY PLC FAMILY RS LOGIX 5000 USING WHICH
PROTOCOL?
- 2 Answers
- 7423 Views
- ABG Shipyard, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / manickam.kc
DF1 protocol is an Allen-Bradley data-link layer protocol
that combines .... Softlogix 5800 provides virtual PLC
control using a PC and RSLogix 5000. ...
The DF-1 protocol is an asynchronous byte-oriented protocol
that is used to communicate with most Allen-Bradley RS-232
interface modules. More specifically, the DF-1 serial frame
composition is that of a conventional RS-232 serial frame,
where DF-1 forces some of the serial parameters such as 8
data bits, no parity, and a maximum baud rate of 19200.
Further, the DF-1 protocol specifies how to send data
through a conventional RS-232 serial port, in order to
communicate with the corresponding Allen-Bradley products.
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / viray patel
MOSTLY USE TCP/IP PROTOCOL BECAUSE IT`S LARGEST USE IN
NETWORKING SYSTEM.
| Is This Answer Correct ? | 3 Yes | 3 No |
Do switches use ip addresses?
Can the IP address same for 2 pcs?
How to instal two operarting system in one pc?
What port can I use instead of 80?
What are the 4 types of laws?
What is the port 8000?
What is j std 001 certification?
Is port 80 open on my network?
What is the difference between unidirectional and bidirectional?
diff between frame relay and isdn connection
What is routing protocol and its purposes?
What does tcp/ip stand for?
SNMP 
