Respected sir please send placement paper of bpcl

2749

How many full enterprise project have you done?

121

plz give sample question paper of hpcl thank you shinde_murali@yahoo.co.in

2060

How to increase the internal logging in orbix configure?

837

What if I write static public void instead of public static void?

948

How to validate email using jquery?

974

The CST assessement for the FY 2006-07 is completed on 31-3- 2010 and the same is received by dealer on 22-4-10. The question is that the dealer colud not produced the original H Forms at the time time asst. except the photostat copies filed. But the CTO not allowed and calculate tax at net 4% on H Forms turnover. CTO is saying that it is time barred by 31-3-10. Therefore even after produced we can not revise. We filed with case laws that it can be revised But when it is time barred it canot be. Therefore I request You to help the dealer ANYCASE LAW is there in the above case Pl. guide us.

2266

hi friends pls send the bhel question papers is very urgent...

2365

What work you have done in HR module

1463

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

2262

Explain how to edit location for weather?

965

can any one know about NIC (National Informatics Centre) questions Patterns and full detail about written exam, and interview send to softshikha2005@yahoo.com.in Thank you

2160

Dear concern Plz provide me the solved papers of Railway section engineer in signal...

1992

Find Best Job Vacancies across the world on Jooble!

145

Can anybody explain with the help of sketeches that what are 2legged , four legged & 6legged stirrups and how to calculate cut length of diamond ring(stirrups)?

2094