Write a progarm to find the length of string using switch case?
What is your long-range objective?
Explain the benefits of using standard terminology in the measurement process?(Tendering and estimation)
What are your key strengths as a System/network Administrator?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. email@example.com
What is the technical difference between On delay timer and a Star delta timer?
I Want build and release interview questions
How to Declare a SafeArray in the type library editor?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
what are all the conversion and interfaces in GL,AP,AR,HRMS with example? otherwise send send link for these
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
4.1 Supply contracts (in the form of comments specifying pre- and post conditions) for the enqueue() method of the LinkedQueue class given in the Appendix. (2) 4.2 Let Thing be a class which is capable of cloning objects, and consider the code fragment: Thing thing1 = new Thing(); //(1) Thing thing2 = thing1; //(2) Thing thing3 = (Thing) thing1.clone(); //(3) Explain how the objects thing2 and thing3 differ from each other after execution of the statements. (
what are the methods to measure managerial effectiveness
Can anyone help me in educating me in installing SAP 4.6C over windows server 2000. Please make it a step by step process, my career depends upon the success and failure of installation.
State a generalized process for load test? Or explain how you did it previously.