define client activated objects (cao)?

1075

---

Is windows xp dead?

798

---

What is object stores?

992

---

How do I make a chart sheet?

677

---

Draw vi characteristics of pn junction diode.

1108

---

Have you designed ui, user interface?

805

---

What is the Difference between sax and dom parser?

1057

---

What do you understand by the term instance?

951

---

Explain some of the accrued expenses and the accounts in which you would record them?

1083

---

What is threading in c# with example?

923

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

2250

---

What is the cause of cylindrical liner overheating?

1807

---

What is the purpose of a file?

989

---

Explain the difference between inprocess vs out process session state : Dot net architecture

1087

---

Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?

1915

---