1.dg on load alarm/stop alarm...
2.dg on load.
piu alarm
alarm kaise chek krte hai
- 1 Answers
- 2027 Views
- GTL, I also Faced
- E-Mail Answers
Answer Posted / Archana Singh
To check DG On Load, DG On Load Alarm, and Piu Alarm in electrical systems, you would typically refer to the system's manual or schematics for proper testing procedures. These alarms are often indicated through visual or audible signals on the device or control panel, or by monitoring system parameters such as voltage, current, or power factor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
i am in need of AC SYNCHRONUS MOTOR 30KW. ANY ONE KNOWS THE MANUFACTURER OF SAME. ALSO MOSFET AC CONVERTER 20KVA CONT.OUTPUT.
How much minimum insulation required between 11kv/3.3kv transformer windings?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
I am going to appear RRB Sr. Section Engineer Exam, Electrical. Can you send me previous year questions of RRB Electrical engineer. specially Section Engineer questions. my email id is likerahulworld@gmail.com
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
CBCT selection
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
How to calculate the sag on transmission Lines.
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
Sir, I have applied for the of Jr.engineer(Electrical & Electronics) & ASST. LOCO PILOT at ALL RRB BOARDS. please send me all RRB Boards solved papers in the year of 2001 tO till date. i requested send me the papers to my id as soon as possible (jet_0991@yahoo.com). (This is very urgent) Thank You,
