Interested to Buy Any Domain ? << Click Here >> for more details...
In Induction machines which type of emf is induced ( statically or dynamically)?
- 1 Answers
- 2594 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandni
Dynamically induced emf
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
how calculated Transformer losses.
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
How much no load current of synchronous motor
how to compute kvar in substation feeder to improve power factor and sending voltage
how to differentiate a mpcb,mcb with a contactor? Explain their working operation
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
What are the functions of temperature scanner in power transformer?
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
What does the letter CTNM in negative phase sequence relay means?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
what are the steps involved in generator load test?
