What is the power ratio between power in Star and Delta
circuit?
Answer Posted / sasi karthick a
The power is depends on the resistance of the winding. Lets
Take "R"ohm resistance of winding and connect in star
configuration.
then transform it to delta. You will see the result. It
will "R/3". So low resistance, high current, power.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the parameters plays a major role in Potential transformer Burden calculation??
For high frequency application we use which transformer?
sugest any typical project ?
what are the application of over current relay?
what is the difference between online & offline caliberation of KWH meters. Can Digital meters be caliberated
what happens if earth of 33kv cable is not connected to earthing pits? please send this query's answer to ngrm.sudha249@gmail.com
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
Meaning of ingrace protection for motor.for ex IPXY
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
What are the two major types of control system?
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
how can you calculate fault level ?