Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / santosh kumar
I think types of switchgears should be define as per two
things.1st Useing of di-electic i.e Air,Vacume,Oil etc.
2nd operational i.e Tharmal, magnatic etc.
| Is This Answer Correct ? | 7 Yes | 6 No |
Post New Answer View All Answers
what does a k rating in a transformer means?
Difference between earthing & grounding.?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
What is difference between insulating medium and fault current interruption medium in a switching device.
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
What does Bode plot tell you?
what about the power of wattmeter at starting and loding?
what is difference between speed mode and torque mode in motor?? explain in simple words please.
what is meant by power and distribution transformer ?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is the percentage loss for aluminium wire for HT line more than 11KVa
Can you explain about TEE protection scheme?
