Interested to Buy Any Domain ? << Click Here >> for more details...
What types of motors are used in cranes
- 9 Answers
- 42671 Views
- BPDB, BUBT, CNH, I also Faced
- E-Mail Answers
Answer Posted / anil
d.c. series motor
bcoz its starting torque is high and also speed is inversly
proportional 2 load
| Is This Answer Correct ? | 48 Yes | 14 No |
Post New Answer View All Answers
Explain what are inter-poles and why they are required in a dc machine.
is IS says that neutral should be brought to switch box. and this one is a recomended practice
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
Why power factor should not be in leading (capacitive) mode of any load.
What is the meaning of 40X8X2 busbar dimensions for carring load of 400 Amps
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
What is the function of electron gun used in crt?
ht side line to earth voltage
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is per unit calculation?looking for simple and strong explanation thk u
What is the effect of pd controller on system performance?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
