What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 23871 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / sachin lakhe
C.T means Currents transformer which works as normaL
Transformers use to mesure current in primary.
we r using coil to show the current in ratio.
Exa- 400/5 means if primary is 400amps then secondry will be
5amps.
Just we r making suitble current for ameter coil.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
What is meant by control system?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
How many VSC based HVDC are there in India and the world
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it
what the principle of sincroscope?how it works?when it needed?
what is the voltage between earth to neutral in lift.
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
how to find out 3 phase complex power in per unit in unbalanced system?
Is there any standard guidelines/Criteria to design NGR/NGT.?
LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
How Self works in DG set
