Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / m. saravanan
man machine interface - MMI
History module interface - HMI
| Is This Answer Correct ? | 1 Yes | 21 No |
Post New Answer View All Answers
What is Erosion in a control valve?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what is the difference between profibus and controlnet networking.
Explain bernoulli’s theorem.
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
What is difference between Ionization heat and bimetallic heat
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Why ac supply load cell is used? Can we use the dc supply load cell?
How it the difference between force balance system and dispalacement balance system?
How does temperature bath work? How does coil gets heated only by applying some current?
What is frequency factor in massflow meter? When using frequency output?
what is 24vdc live and dry supply
Why trim span ? How?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to calibrate an pressure gauge with yantrika test bench?
