Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERNCE BETWEEN AIS AND GIS IN SWITCH GEAR?
- 5 Answers
- 24722 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / a.yougaraj
AIS: AIR INSULATED SW. GR.
GIS: GAS INSULATED SW. GR.
| Is This Answer Correct ? | 35 Yes | 7 No |
Post New Answer View All Answers
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
how to select the no. of brushes in a lap winding?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
Can we transmit digital signal to long distance ?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
how we can calculate chiller required ampear?
What are the types of feedback oscillators?
give single line diagram of D.G distribution form alternator to main L.T panel?
Why have to use copper cable for local isolator to motor ?
how much excitation voltage required to generate 1mw power?
what is consequences of neutral and earth connect?
What is safety of Ht panel
