Interested to Buy Any Domain ? << Click Here >> for more details...
Why Transistors are not used as switching devices?
- 15 Answers
- 31066 Views
- I also Faced
- E-Mail Answers
Answer Posted / niranajn
since a transistor is bipolar as the conduction is due to
both electrons and holes
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
Explain the difference between verilog task and verilog function?
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
Details about Flux Compensated magnetic Amplifer starter for motors
what is the difference between circular wdg & ractangular wdg?
Why ground terminal is used in pot meter 10k ohms
how many joint can done in HT line and what is life of the joint
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
