How to calculate busbar size & what is the procedure we
make for determine that?
Answer Posted / jaydev jena
current density= .8 amp/sqmm.that does mean 1sqmm can carry
0.8 amp current .if sisze of busbar is 100mmx 10 mm then it
can carry 800 amp.
Is This Answer Correct ? | 61 Yes | 25 No |
Post New Answer View All Answers
Is vtg is controlled by the resistor? if else how much?
why connecting surge unit in contactor coil
two way ckt diagram can be drawn by how many ways? give diagram
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
Is potential difference materials property ..? if yes tnen how.. explain brifly.
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
How isolater function when installed inelectrical 440V wiring
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
bsnl tta exam question
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?