ALLInterview.com :: Home Page
 Advertise your Business Here     
Browse  |   Placement Papers  |   Company  |   Code Snippets  |   Certifications  |   Visa Questions
Post Question  |   Post Answer  |   My Panel  |   Search  |   Articles  |   Topics  |   Errors
   Testimonials Refer this Site  Refer This Site to Your Friends  Site Map  Contact Us      
   
 
Categories >> Engineering >> Electrical Engineering
 


 

 
Question Why a starter is used for a motor?
 Question Asked In Companies :: L&T,     < I also faced this Question! >
 Question Submitted By :: ravi
  Answer Posted By  
 
Answer
generally the resistance of armature is very small i.e in
term of .05ohm or like this.this is due to reduce the
losses.if the motor is connected direct supply high current
will flow and it may burn the armature winding.thats why
starter is connected between supply and motor which reduces
the starting current and provided smooth operation

Is This Answer Correct ?    110 Yes 17 No


 
  sabyasachi kanungo
 
View All Answers
 
 
Please Help Members By Posting Answers For Below Questions
 
 Question Views   Select
 
What are IR values and what it should be for coil and for insulator 1155
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m 260
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge? 211
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example. 414
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC. 329
how to calculte capacitor range for single phase induction motors??pls tel 326
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ? 366
what is Anti-pumping? 209
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator 252
while calculating the power absorbed by a resistor connected to the output of a half wave rectifier circuit should we use rms or average current? explain with reason. 426
how to work droop ct in generating station 586
what the Microsoft .NET framework is? 244
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example? 272
how harmonics generated in induction furnance? how minimise it? 433
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 264
E-Mail New Answers        Answer Selected Questions