how fault in an electric system is detected & hw protection
of equipments is done ?
Answers were Sorted based on User's Feedback
Answer / shyam
fault is indicated by the relay & protecction is done
through the ciruit breaker after identifying the fault.
Is This Answer Correct ? | 10 Yes | 0 No |
Answer / himanshu batra
fault is detected with the help of circuit breaker and relay
Is This Answer Correct ? | 12 Yes | 5 No |
Answer / mandar
whenever there is a fault in the system there is some change
in electrical parameters like freq, voltage, current, phase seq.
by detecting the changes in those parameters using relays we
can protect the electrical system
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / riya
Fault is detected by C.B trip or O/L trip.Protection of
equipment is done bu providing earthing, using good
insulation & Using O/L relays.
Is This Answer Correct ? | 4 Yes | 3 No |
Answer / purusottam nayak
THE EECTRIC FAULT CAN BE DETECTED BY INSTALING VARIOUS
RELAYS LIKE;O/L RELAY,U/V RELAY,EARTH FAULT RELAY,DISTANCE
RELAY SUCH ON.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / praful nandankar
Fault is sensed by any relays and faulty section is
isolated with the help of circuit breakers.The circuit
breaker is operated when the moving contact is pulled by
some mechanism.The moving contact is pulled against the
effect of spring.It moves only when the fault occurs in the
system.
Praful nandankar
Is This Answer Correct ? | 1 Yes | 0 No |
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
* Signal transmission in sky wave propagation is due to ? a) Reforction of wave b) Reflection of wave c) Pierus through Inosphere d) None and Reason for this is????
Why is starter necessary for a three-phase induction motor?
37 Answers BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt,
what are the points to be consider for MCB(miniature circuit breaker selection?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
wat is the difference between real power and reactive power..which is useful..?and how it s useful..wat is the effect of these on a power system...
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
without any excitation we can strt any dc or ac moter?
I've descovered that when the earth wire in a domestic electrical installation is not connected back to the board (ground) a voltage of between 9-24v is is found to be present in the earth wire. When connected at the board there is no voltage - is this normal and why does it happen?
how much Hp motor is required for water suction pump in home uses ?