What is static frequency control used in gas turbines



What is static frequency control used in gas turbines..

Answer / jithu toms

while starting gas turbine(generater) ,it should be started
as an induction motor,so need to adjust frequency to obtain
desired speed, after that by combustion of gas it will run
and induction principle will cut off..This frequency
controlling is done by sfc.

Is This Answer Correct ?    1 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

How many types of Differential protection are there? and what the special arrangement are made at the time of charging of a transformer on the Differential protection?

1 Answers  


Distinguish between neutral earthing and equipment earthing?

7 Answers  


We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible

0 Answers  


Why the generator rating in kva

32 Answers   CompuCom, DLF, Genpact, HNG, SIPM,


for any load, what happen if we use the cable rating above its normal rating

2 Answers  






in 33kv line how much current will be

3 Answers  


Efficient electrical earthing in hard rock area

0 Answers  


How we calculate the spacing between the conductors in 11,33KV lines?

3 Answers   NHPC,


difference bteween neutral grounding resistor and neutral grounding transformer??

1 Answers  


what purpose to use excaiter in DG.?

0 Answers   TATA,


what is the applicatyons of the slipring motor and please tel me more about the slipring concept

1 Answers  


when we switch on the switch and load is not connected at home,is electricity wasted?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)