| Other Electrical Engineering Interview Questions |
|| Asked @
|how was the induction stove working?
|what is post close & pre close of trip circuit supervision
relay in circuit breaker control scheme?
|How do we calculate the out Put voltage of generator, after
excitation being given?
|how much loading in terms of ampere can put on 5 MVA,33/11
KV TRANSFORMER having rated current 263 Amp ?????????
|my N-P 230 VAC at 3 wires but i haven't any voltages at phase
to phase whither my supply is 3 phase, why i haven't received
these line to line voltages ?
|why we step down voltage level from 33kv to 11kv and 11kv
to 415v.Instead we can step down voltage from 33kv to 415v
directly using single transformer.
|To test Transformer we give HT side 440V to see wheather
that it is producing 17.6V on LT to verify Voltage ratio is
correct or not but when we give the 440V voltage to LT side
then what will happen to HT voltage ?
|WHAT IS BASICS TO SELECTION OF 11 kv Trasformer, send any
calculation sheet for selection of transformer
|how give earthing to shif and aeroplane which is away from
|400kw, 3.3Kv motor want to fix 1000km away from substation.
What is full load current? and what is the cable size for
motor? I amp expecting answer and advice from your side..
|for 500mw power production how many range of transformer
set in unit please reply if three transformer use .
|what is the switching substation
|For more Electrical Engineering Interview Questions Click Here |