| Other Electrical Engineering Interview Questions |
|| Asked @
|what is different between IP55,IP54 and IP66?
|how work the differential protection relay in details?
|we all know that both the generator and motor are
electromechanical conversion devices.....then why we rate
motor in kw and generator in kva????
|Why are transmission lines multiples of 11? Is it because of
some historic reason ? Or is there a scientific base to it?
|when we connect the capacitor bank in series
|what power factor should we maintain to get maximum benefits
our organisation load is 10 MW?
is it best to maintain the PF at .96 rather than Unity to save
|Can I parallel 1 MVA generator with 1kVA Generator? if V, F,
Ph Seq and Ph angles are same
|IN PLATE EARTHING , PLATE LAID IN VERTICAL POSITION ,WHY
HORIZONTAL WHY NOT
|What is the Frequency while we step up the voltage from
11KV? Is it possible? Explain it?
|hi frienda We have 750kva cater pillet dg set we are fasing
one diffrent proublam in dg we are start dg set after one
mint applying load around 450a load but dg was run 3 Or 4
mints after 3 mints dg was shuding down automatic how to
face this proublam pls tel any budy
|Hi, what is 100 % stator earth fault protection and how it
can be achieve by 3rd harmonics and low frequency injection
|what will hapen if secodery circuit is open of current
WHy neutral to ground trips when neutral touches the ground
|For more Electrical Engineering Interview Questions Click Here |