1 what is the number of telnet session in the cisco router a 1 b 2 c 3

Advertise your Business Here

Refer this Site

Login | Sign Up


	To Refer this Site to Your Friends Click Here

Categories >> Certifications >> Cisco Certifications >> CCNA

CCNA Interview Questions

CCDA Interview Questions

Question

1 what is the number of  telnet session in the cisco router
a 1
b 2
c 3

d 4
e 5

Question Submitted By :: Jitendera Kumar Sinha

I also faced this Question!!

Rank

Answer Posted By

Re: 1 what is the number of telnet session in the cisco router a 1 b 2 c 3 d 4 e 5

Answer
# 1

I don't knw eactly.. watever i knw... "No of telnet
connection" at a time is equal to the "no of virtual
terminal supported by the router"

Is it ryt???

Is This Answer Correct ?

0 Yes

1 No

Shahin

Re: 1 what is the number of telnet session in the cisco router a 1 b 2 c 3 d 4 e 5

Answer
# 2

yeah i was also confused in that question. what is that?
sudenly one thought comec in mind that
router(config)#line vty 0 4
so to counting 0 4 i am mark the answer 5 that is e
so i am little bit confused that is that wright answer.
if any one know plz tell

Is This Answer Correct ?

0 Yes

0 No

Jitendera Kuaar Sinha

Re: 1 what is the number of telnet session in the cisco router a 1 b 2 c 3 d 4 e 5

Answer
# 3

option e: is write 0-4 virtual lines count 0 line as 1 soon
  
and one more thing its for old switch r routers, new one 
has 16 lines ie. 0-15 and can be more depend on series of 
router or switch...

Is This Answer Correct ?

0 Yes

0 No

Mahesh

Question	Asked @	Answers
Other CCNA Interview Questions


Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface		1
Which three protocols are corerectly matched to their transport layer functions? (Choose three) A. route selection IP B. sliding window UDP C. well known pods IP D. route validation ICMP E. connection oriented TCP F. three way handshake TCP G. no sequence and acknowledgement UDP		1
Which technologies listed below help prevent network loops in a switched (bridged) environment? A.) Store-and-Forward B.) IEEE 802.1d C.) Diikjstra Algorithm D.) Cut-Through E.) Spanning Tree Protocol F.) Routing		1
Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End		1
You have a Frame Relay link on serial 1. Which command displays the Local Management Interface (LMI) data link connection identifier (DLCI) and bandwidth for that link? A. show interface serial1 B. show frame-felay serial1 C. show protocol frame-relay serial1 D. show serial1 encapsulation frame-relay		1
When you issue the command show version your router returns "Configuration register is 0x0101" From where does the router boot? A. ROM B. NVRAM C. Flash D. a TFTP server		1
Can anyone explain the Split Horizon rule in RIP & also Split Horizon with Poison reverse. Jitu.... U knw wat i expect.. hehehehehe...		1
Identify 3 LAN technologies? A.) FDDI B.) HDLC C.) HSSI D.) X.25 E.) 802.3 F.) 802.5		1
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction		1
What is the command to manually enter a static route? A.) IP route network B.) IP route C.) IP route < destination network> D.) IP route		4
What are the job opportunities i will get once i complete my CCNA certification.		2
Which of the following is an example of the Network Layer? A.) TCP B.) IP C.) SQL D.) Token Ring E.) LLC		1
Which OSI layer provides best effort end to end packet delivery? A.) Data-Link B.) Presentation C.) Network D.) Transport E.) Physical F.) Application	Barnes-and-Noble	2
There are 2 types of PPP authentication supported by the Cisco IOS. What are they? A.) PAP B.) PREDICTOR C.) MD5 D.) CHAP E.) STACKER F.) MSCHAP		4
What does the command “IP name-server 255.255.255.255″ accomplish? a.It disables domain name lookup. b.It sets the domain name lookup to be a local broadcast. c.This is an illegal command. d.The command is now defunct and has been replaced by “IP server-name ip any”		5
Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame		1
What should be the first command to create an access-list that prevents all users on subnetwork 10.10.128.0, using subnet mask 255.255.192.0, from being able to telnet anywhere? A.) access-list 101 deny tcp 10.10.128.0 0.0.63.255 any eq telnet B.) access-list 101 deny tcp 10.10.128.0 255.255.0.0 any eq telnet C.) access-list 101 deny tcp 10.10.128.0 255.255.192.0 any eq telnet D.) access-list 101 deny tcp 10.10.128.0 0.0.192.255 any eq telnet E.) access-list 101 deny tcp 10.10.128.0 0.0.128.255 any eq telnet F.) access-list 101 deny tcp 10.10.128.0 0.0.127.255 any eq telnet		3
What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase		2
What is the Broadcast MAC Address?	Avaya	2
intial information of packey occur on which layer application sessions physical mine answer physical		1

For more CCNA Interview Questions Click Here


Copyright Policy \| Terms of Service \| Help \| Site Map 1 \| Articles \| Site Map \| Site Map \| Contact Us \|

Copyright © 2007 ALLInterview.com. All Rights Reserved.

ALLInterview.com :: Forum9.com :: KalAajKal.com